2015 Blessing Glass Reci CO2 Laser Tube 80w-150w Price
100W Reci Laser Tube adopt new technique of production and inflation formula for co2 gas, to ensure the high quality and stability of glass laser tubes. The lifetime of laser tube is up to 10000 hours, laser power is from 80 watts to 180 watts, it is very popular in thickness materials cutting
Specification of Reci Laser Tube 100W:
Make sure to follow the operation instruction of model Z4 as shown in the illustration. The dedicated power DY13 should be equipped. The positive pole of laser tube is in high voltage (the ignition voltage is 24kv).It may cause the following consequence when it is failed to follow the instruction: Arcing; the inner tube will be punctured by electricity and may cause water leakage
Water cooling: using purified water; 3 to 5 liter/minute; water temperature: 10℃-40℃The operating
environment: temperature 2-40℃; humidity:10-60%
The working current: test current is 30mA. Maximum working current is 30mA. The running current
must be kept below 28mA.
The life span can reach 10,000 hours if the current is kept below 26mA.
The ammeter must be connected to the negative electrode of laser tube.When it is working under over. High current for long term, the negative pole will appear brown yellow, and the life span will be shortened rapidly.To protect dust from going into the insulation sheath, please wrap it with plastic film.
Do not clean the exterior surface of the output widow mirror with tools such as tampon; otherwise
the output power will be seriously affected. The followings are the designated methods to clean up
pollution in the exterior surface of window mirror:
When the mirror is polluted, do not turn on the laser.
Blow the mirror surface sideways with an air blower.
Spray the pure alcohol on the mirror surface with sprayer.
Turn on the laser after the alcohol gets fully volatilized.
If the methods above don't work effectively, it is necessary to ask for the professional to use tampon
with alcohol to clean the mirror surface from middle to edge. The best solution is to prevent the
Attention: it is forbidden to clean the mirror with acetoneThe screws in the front and back ends of the laser tube are not allowed to be moved, otherwise the out power will be declined, even the tube will be scrapped.Put the acryl 300mm far away from output mirror, when testing its laser spot.
The laser beam is invisible light. Please wear protective glasses when debugging the laser.
The positive pole is in high voltage. Pay attention to the security marks.
5.Storage and Transportation Requirment
Pour out cooling fluid in the event of storage and transportation, and cover the output terminal with a dust-proof plastic bag. The storage environment is 2-40℃, and the requested humidity is 10-60%.
Pack the laser as in the original way. Important notes: it is requested to use adhesive tape to cement
the sponge together with laser tube to prevent the tube from vertically sliding during transportation.
The sponge in the side of output mirror must be 70 mm beyond it, and the sponge in the side of